SPDT & DPDT DUPLEXOR ARP Series
Alternating Relays are used in special applications where the optimization of load usage is required by equalizing the run time of two loads. This alternating action is initiated by a control switch, such as a fl oat switch, manual switch, timing relay, pressure switch, or other isolated contact. Each time the initiating switch is opened, the output relay contacts will change state, thus alternating the two loads. Two LEDs indicate which load is the next to energize.
The Alternating Relays listed on this page can be used with one or two control switches and are available in either SPDT or DPDT output confi gurations. For products with DPDT Cross-Wired output confi gurations to be used with one, two or three control switches, DPDT Cross-Wired Duplexor.
Each version is available with an optional three position selector switch. This allows the unit to alternate the two loads as normal, or lock the relay to one load or the other. By locking the Alternating Relay to one load, the other load can be removed for service without rewiring the fi rst load for continuous operation. The selector switch has a low profi le to prevent any accidental changes in status.
|
|