1422 Series Two Door Floormount Enclosures - NEMA 12
Continuous Hinge
Application
Designed to house electrical, electronic, hydraulic or pneumatic controls and instruments.
Provides a degree of protection from falling dirt, dust, oil and water.
Standards
UL 508 Type 12
CSA Type 12
Complies with
NEMA Type 12
IEC 60529, IP54
Construction
Enclosures 54" high or less are formed 14 gauge steel.
Enclosures 60" high are formed 12 gauge steel.
Enclosures 72" high are formed 12 gauge steel with a 10 gauge steel back.
Smooth, continuously welded seams without knockouts, cutouts or holes.
Body stiffeners are provided in enclosures for extra rigidity.
Heavy duty lifting eyebolts are provided with reinforced support angles.
12" floor stands are welded to the enclosure. (w/ feet Part No.).
Welded brackets provide for enclosure mounting (w/o feet Part No.).
Gasketed overlapping doors eliminate the need for a center post.
Continuously hinged doors may be removed by pulling the hinge pin.
Doors are secured with a three point latch and operated with a key locking automotive type handle.
Latch rods are equipped with rollers for easier door closing.
Oil resistant gaskets are permanently secured.
A removable 10 gauge inner panel is included in enclosures 60" and larger. Smaller sizes include a 12 gauge inner panel.
Panel supports are provided in enclosures 60" and larger for easy panel installation.
Collar studs are provided for mounting inner panels.
A grounding stud is provided in the enclosure for each door and a bonding stud is provided on the door.
A literature pocket is provided for the inside of the door.
Finish
Cover and enclosure are phosphatized and finished in
recoatable smooth ANSI 61 gray powder coating on the outside, with
white powder coating on the inside.
Removable inner panel is finished in white powder coating.